Wansview B Series Bedienungsanleitung PDF herunterladen (Seite 17)

H Series IP Camera User Manual - Waterproof

Before using UPNP function, please make sure the router’s UPNP function has

been triggered. Because there are so many different routers, and not all of them

can support UPNP. Please test if the router work well with the equipment, if not, we

would suggest you don’t enable this function.

Figure 18

7.3 Alarm Setting Page

7.3.1 External Alarm Input

Figure 19 below has listed the external alarm input setting. If the alarm input pins have

connected with an alarm detector, please tick the “External Alarm”, and then you will have

enabled external alarm function. If the external alarm detector is open mode, please tick

“Open”, vice versa.

Figure 19

7.3.2 Motion Detection Setting

If user wants to monitor a certain area’s movement, please select the motion detection to

trigger alarm. The motion detection setting page is showed in Figure 20. This equipment

supports four areas settings. By ticking the options, on the screen, it will show you the area

frame, and the areas are numbered. Using the mouse to drag the area frame, you can

change the position of the frame, and to drag the right bottom corner of frame, you can

change the size of frame. After setting is finished, click “Apply“ button, then the motion

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 27 28

Keine Kommentare

Wansview B Series Bedienungsanleitung Seite 17