Wansview NCM629W Bedienungsanleitung PDF herunterladen (Seite 12)

http://www.wansview.com

Figure 5

Select ‘On’ and click ‘Search’, and then select wireless router in pop up menu, click ‘OK’

and enter its password, click ‘apply’ to save the wireless settings. And you can click

‘check’ to check if the wireless setting is successful. After setting successfully, please pull

out network cable and reboot the camera to use the wireless connection to view video.

Because the camera supports WPS/QSS, so you can set wireless by simple way as

below.

1) Please confirm if the router connected to camera supports WPS/QSS (you can

check user manual of the router or get the support from router factory);

2) Press WPS/QSS button on the router, it will launch the function.

3) Press and hold on reset button for 2~5 seconds after it ran normally （ not need

connect cable）, it will launch the WPS/QSS function, then match the setting with the

router, the status LED always on when it was matching, and it will flash after

matching successfully.

4) Unplug power adaptor and reboot the camera, then you can use the wireless

connect function.

Note: The camera will automatically stop the function when the matching is unsuccessful

after continuing 50 seconds. Due to different kinds of the router, we don’t sure our

camera can be connected to all routers successfully.

2.4. View video in internet

You should connect your internal network to the internet first and configure port

forwarding, consult your router’s manual for further details, as figure 6.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 33 34

Keine Kommentare

Wansview NCM629W Bedienungsanleitung Seite 12